Dryer plug in6/29/2023 When your installers say "it's safe", they mean "it's safe FOR THEM" because they won't be using your range. The fact that yours was installed prior to 1996, and is thus "grandfathered", does not make it any safer. This was banned in 1996 because of the body count. You are asking is it safe: Installing a NEMA 10-50 range socket. If the cable had 3 inslated conductors, you could use it as is or you could retrofit a ground, but you cannot retrofit a neutral. You could use a 3-wire appliance cord and plug it into this receptacle and the range would work perfectly, but if the range requires a neutral, then current will regularly be flowing in the uninsulated conductor. If it does, then you will need a new (4 wire) cable. It should tell you whether it requires a neutral. Look at the installation instructions for the range. Unless your new range is a special design which requires only 240 V, you must replace this cable all the way back to the panel or subpanel if there is one. What are the requirements of your new range? It is not suitable for any appliance which requires both 120 and 240 V. This cable can legally supply 240 V, not both 120 V and 240 V. The cable is wired to the receptacle using the uninsulated conductor as a neutral. It appears to me that this cable has two insulated conductors for the two hot legs plus an uninsulated conductor to be used as a ground, i.e., it does not have a third insulated cable to be used as a neutral. Given that, is it ok to assume that the wiring for this circuit is also safe up to 40A and I truly can just swap the receptacles and call it a day?ģ0 amp dryer plug is hooked to a 40 amp double breaker, is this ok? indicates that the current setup maybe shouldn't have existed in the first place so I'm trying to be cautious about how I fix this.Įdit: here are some pictures of the wiringĮdit 2: full electrical panel and back of receptacle Shows that the old circuit has a 40A breaker. The delivery guys were adamant that all we had to do was pop over to a store and swap out the receptacle in order to get it working.īased on Dryer Outlet in the kitchen?, I'm skeptical that it will be so simple. Essentially, the old range was connected to a 30A "dryer socket" in the kitchen while the new one requires a 40A "range socket". Today we had a new range delivered and ran into an issue trying to install it. Just bought a house built in 1979 and am working on renovations.
0 Comments
Leave a Reply. |